MIL-T-27/1628
Electrical characteristics:
Inductance: The inductance in table I is measured with 1.0 volt rms, 60 Hz across (1-4) with (2-3)
connected, and 0 A dc applied to (1-4).
NOTE: After group III (environmental) and group IV (life) the inductance shall not change more than
15 percent and "Q" shall be 22 minimum. Marking location: See figure 1.
Part or Identification Number (PIN): M27/162-(dash number from table I).
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. 8idders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-PRF-27, this document references the following: MIL-STD-202
Custodians: Preparing activity: Army - CR DLA - CC
Navy - EC
Air Force - 85 (Project 5950-2009-007) DLA - CC
Review activities: Army - CR4, MI
Navy - AS, MC, OS, SH Air Force - 19, 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business