MIL-T-27/175C
Design and construction:
Dimensions and configurations: See figure 1. Duty cycle: Continuous.
Terminals: Solder lug type, ST-1708 or equivalent.
Terminal height: .266 ±.031 inch. Weight: 0.454 kilograms, maximum.
Operating temperature range: -55°C to +105°C.
Terminal strength: MIL-STD-202, method 211, test condition A, 5 pounds. Shock (specified pulse): MIL-STD-202, method 213, test condition H. Dielectric withstanding voltage (at sea level): 1000 V rms
Electrical characteristics: Inductance:
Series connected: With 1 V rms, 60 Hz across (1-4), and 0 ampere dc applied to (1-4) the inductance shall be as specified in table I.
Parallel connected: With 0.5 V rms, 60 Hz across (1-4), and 0 ampere dc applied to (1-4) the inductance shall be as specified in table I.
Q: At 1 V, 50 Hz, the Q shall be as specified in table I. VERIFICATION:
Qualification inspection: Not applicable.
Conformance inspection: Groups A and B tests of MIL-PRF-27 shall be applicable. Marking location: See figure 1.
Part or Identifying Number (PIN): M27/175-(dash number from table I).
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-PRF-27, this document references the following: MIL-STD-202
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business