MIL-PRF-83446/4D
Electrical characteristics (final): See table II.
TABLE II. Electrical characteristics (final).
Inspection
Allowable variation from initial measurements
group
DC resistance
Self-resonant
Q
Inductance
frequency 1/
(Percent)
(Percent)
(Percent)
Qualification
inspection
±(3% +.001 ohm)
±5
-10
-8
Group II
±(2% +.001 ohm)
±5
-10
-10
Group IV
±2
-10
---
Group V
---
Conformance
inspection group C
±5
±(3% +.001 ohm)
-10
-8
Subgroup II
±5
±(3% +.001 ohm)
-10
-8
Subgroup IV
1/ Not applicable to self-resonant frequencies exceeding 250 MHz.
Supersession data: A new part numbering system with codes for termination materials was incorporated by previous
revision, superseding the part numbering system of MIL-I-83446/4, dated October 1978.
M83446/04-(dash number from table I) A
Supersedes M83446/4-(dash number from table I).
Examples:
M83446/04-21A supersedes M83446/4-21.
M83446/04-03A supersedes M83446/4-3.
Part of Identifying Number (PIN): The part number shall be in the following form.
M83446/04-
04
B
|
|
Sequentially assigned dash
Termination finish
Numbers (see table I)
(see MIL-PRF-83446)
NOTE: The Government shall not stock the 20 percent tolerance coils. Dash numbers 30 through 36 shall not be
stocked. For Government reacquisition's and stocking, use dash numbers 38, 40, 42, 44, 46, 48, and 50,
respectively. Dash numbers 30 through 36 shall be listed as secondary reference numbers under the respective
national stock number.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business